Skip to content
Home » Honda Outboard Spark Plug Socket Size Guide

Honda Outboard Spark Plug Socket Size Guide

    Honda Outboard Spark Plug Socket Size

    Overview

    If you own a Honda outboard motor, it’s important to know the correct spark plug socket size to ensure proper maintenance and replacement of your spark plugs. Using the wrong socket size can lead to damage or improper installation, which can affect the performance of your outboard engine. In this article, we will provide you with the necessary information to determine the spark plug socket size for your Honda outboard.

    Determining the Spark Plug Socket Size

    To determine the spark plug socket size for your Honda outboard, you can refer to the owner’s manual or follow these steps:

    1. Locate the spark plugs on your Honda outboard motor. They are typically located on the cylinder head.
    2. Inspect the spark plugs and note the size of the hexagonal nut at the top of each plug.
    3. Measure the width across the flats of the nut using a caliper or ruler.
    4. Refer to the chart below to find the corresponding spark plug socket size:
    Spark Plug Nut Size (mm) Socket Size (mm)
    16 16
    18 18
    20.8 21
    22.2 22
    24.6 24

    Using the Correct Spark Plug Socket Size

    Once you have determined the correct spark plug socket size for your Honda outboard, follow these steps to safely remove and install spark plugs:

    1. Ensure the engine is turned off and cool before starting any maintenance.
    2. Using the appropriate spark plug socket, attach it to a ratchet or extension.
    3. Place the socket onto the spark plug and turn it counterclockwise to loosen and remove the spark plug.
    4. Inspect the spark plug for any signs of damage or wear. If necessary, clean or replace the spark plug.
    5. Apply a small amount of anti-seize compound to the threads of the new spark plug.
    6. Insert the new spark plug into the spark plug socket and carefully thread it into the cylinder head by hand.
    7. Tighten the spark plug using the spark plug socket and ratchet, turning it clockwise until it is snug.
    8. Do not overtighten the spark plug, as it can cause damage.

    Conclusion

    Knowing the correct spark plug socket size for your Honda outboard is essential for proper maintenance and replacement of spark plugs. By following the steps outlined in this article and referring to the provided chart, you can confidently perform spark plug maintenance on your Honda outboard motor. Remember to always consult your owner’s manual for specific instructions and guidelines.